Lindy
8/17/2009
The carb intake ring turned out nice...just a small amount of sanding to do to clean up the outflow of epoxy.
Then I sanded the plenum where I 'glassed the other day, and then fit it to the engine again. The clearance is very close, but I'll have to figure out something to seal it to the engine. Next on the list is the front baffles. These are large pieces that are cut down for use with the plenum. Easy to fit, but again, I need to figure out something to seal them to the plenum. The yellow box is the approximate area that I cut away...
I may just use some rubber baffle seal up front here, but I need to do some builder site searching on this...
2.0 hours