Lindy
12/31/2009
Nothing going at work today, and since no one else was working in the shop, and I was in casual clothes, I spent several mini sessions working on the 7 today. First I primed the rear spinner bulkhead and the gap plates. While those were drying, I made some trims on the front spinner bulkhead. The primer dries very quickly, so I was able to go right back to work on those parts, and riveted them together.
Then I started working on the screw tabs. I made these out of .063 as well.
Should be plenty of room to put three rivets on the gap plate side, and the spinner side will get one screw.
They were a real pain to bend to the approximate shape...
See ya 2009!!
1.5 hours