|
|
|
Home
Lindy |
January 2010 January 4th Riveted screw plates, drilled spinner screw holes to final size January 6th Installed nut plates on the spinner bulkheads January 7th Primed bulkheads January 11th Finished spinner (c-sunk holes), started on the smoke oil tank, mics. other January 13th Air vents, again January 14th Hung the flaps, started rudder springs, hooked up the rudder cables January 15th Installed the Tail Lynx springs January 18th Control rigging, empennage fairing January 24th Torque'd control surface hardware, empennage fairing January 25th Finished control surface hardware, empennage fairing nut plate drilling January 27th Riveted nut plates for the empennage fairing screws January 28th Finished nut plates for the emp fairing, finished sanding/trimming/fitting the emp fairing
|