7/9/2007
Tonight was a fun night! I started by riveting the seat hinge to the pans, then riveted those in to the fuselage seat ribs.
Then I cut and bent the pins that will attach the seatbacks. These are in place just so I don't loose them.
I didn't get a picture of it, but I cleco'd the other two seat skins in place in order to fit the center tunnel cover, F-741. That was fabbed up next. The cover, F-741B, is a pre-cut piece that just needs a bend on the forward edge. It's about an eight inch by two and three quarters inch piece of .040.
The supports, F-741A L&R, are Z channel that has several angular cuts made.
After they were cut and smoothed out, the only other thing I did was drill pilot holes in the bottom flange. They get drilled for screws next.
3.0 hours