Lindy
3/25/2006
I started today with the conduit holes in each of the ribs. They were drilled to final size of 3/4" with my unibit. This worked pretty well, but the bit chatters quite a bit in the drill press. Then I deburred each hole with the edge deburring tool, and I'll probably go over each one with a scotchbrite pad or wheel before priming.
Then I cleco'd the ribs to the main spars and cleco'd the rear spars to the ribs to start drilling those holes to size. I only did the main spars today since I don't want to crawl on the floor to drill the rear spars. I ran out to work to borrow a creeper to move around on. I'll drill those tomorrow.
2.5 hours