Lindy
3/16/2009
I started off tonight by installing the battery buss on the right side bay between the sub-panel and the firewall. This seems to be the default location for this when setting up a three buss system.
Then I started on the ANL current limiter. First I installed the base...
I had to put the base a little to the left and down from where most people put it, due to the gascolator. Then I made the copper bar to go from the limiter to the starter contactor.
Then the diodes were installed. The blue one was a pain because I had to take all the copper bars off of the contactors to get to the mounting bolt that the diode goes under. Also put some heat shrink on the copper bars.
The yellow one was super easy.
Both of those are from Van's. I actually forgot I had those when I bought some rectifier diodes at Radio Shack the other day, but those were cheap, so not a big deal.
2.0 hours