Lindy
10/19/2009
Tonight I worked on the right side nav/strobe lights. I took a few more pics along the way this time though to show how these are different than the first set I had of these. The first set was smaller, and I had to use an AL back-plate to cover the cutout of the tip.
Here's the LED plate before the mirror is mounted over it.
Then the mirrors get fit...I had to trim a good 3/16" off all the way around both mirrors. You can see where the writing has been cut off on the strobe side.
All finished up!
I decided to quit a bit early tonight, so the only other thing I did was to put the ends on the strobe wires.
3.0 hours