Lindy
9/21/2009
Short night tonight...I put some filler epoxy/balloons on the plenum so I can sand down the rough areas nice and smooth in prep for painting it.
I also did the right side inlet, no pic. That will make for a very smooth air entry ramp to the chamber.
Then I decided to finally figure out how to get the last bolt in place on the baffles. I was hoping to do it without removing the oil filler neck, but I just couldn't get a socket or wrench in there, so I cut the safety wire, and removed it. Amazing how easy that bolt went in at that point...
Then I reinstalled the oil filler neck, and re-safetied it.
1.25 hours